Question about Mercury
...valve tappet guide plate retainer(s). Remove the valve tappet guide plate(s) Remove the valve tappet(s). Installation NOTE: Lubricate the valve tappet(s) with Super Premium 5W30 SAE Motor Oil ...
...Valve. Also check for any vacuum leaks here are things to do. Clean MAF sensor wires with carb cleaner and toothbrush carefully. This will remove varnish. Check under distributor cap and rotor (1 ...
Question about 2000 Mountaineer
plate it has been back firing, after cleaning start it up and see how it runs, if it improves then you are on to the problem, you will need to do a top engine clean to clean carbon on the valves rings
...plate in order to maintain the proper idle speed. Do NOT attempt to clean the IAC valve. Carburetor tune-up cleaners or any type of solvent cleaners will damage the internal components of the valve. ...
plate and clean behind. If you have idle air control passage leading off from the throttle wall interior you will find the idle air control valve mounted on the side of the throttle with an electrical
Question about 1998 Villager
...valve, still blows, doesn't blow if i disconect the fuel tank wiring plug. how can i test the sending unit wiring to see if it's bad ? test with volt meter ensure its within ...
...plate in order to maintain the proper idle speed.Do not attempt to clean the IAC valve. Carburetor tune-up cleaners or any type of solvent cleaners will damage the internal components of the valve. ...
...that sit around your throttle plate and also get into the ISC valve. Ford has had problems with this for years. you can clean it up with mild degreaser and an old toothbrush and some elbow
...does not stall car drives beautiful but at a stop the accelerater fluctuates up and down but does not stall The idle air bypass valve or the throttle plate could be gummed up and in need of
Question about 2000 Mystique
...at light it will however start right back up. It also will not cut off if I drive in 2nd gear Sounds like a throttle body issue or idle valve problem. I would clean the throttle plate and idle ...
Usually answered in minutes!
1,305 Questions
689 Questions
627 Questions
646 Questions
630 Questions