...bent a valve causing the engine to loose compression can you help me? just put a compression gauge on each cylinder that will let you know if engine has a bent valve, gauges are relatively cheap. if ...
Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1
...bent push rod in a brigg 14.5 hp motor what might be causing this This is a vary commom problem with an Intek engine, I have a similar 21HP engine with similar issue. The valve is sticking in the ...
...bent valves, take the valve cover off and ck the valve clearances, if you have any that are "way loose" you have bent valves. If you ck them and they are real close, just a little loose, adjust the ...
...bent rocker stud are a few things that come to mind. Take off the valve covers and with each cylinder at top dead center, check the play on each rocker assembly and inspect for any bent parts. ...
...bent valves which prevent the valve spring from closing completely (the valve stem gets caught in the valve guide, preventing complete valve closure). This causes the rocker arm to work it's way out ...
...valve cover already off). check compression. if its low (below 125psi) its most likeky jumped. Usually it wont sound normal when turning the engine over. it it has jumped, you will have bent valves. ...
...valve cover off and it appears that 2 valves are bent/fried. There may be more, but all the rest are very tight and these two on # 4 cylinder have their rockers sloppy loose- indicating that the ...
...valve or liter noise my 2000 neon makes a loud ticking noise what could be the problem It could possibly be a bent connecting rod, a bent / broken pushrod, broken spring, loose rocker or even a loose ...
...valve train [burnt,bent,sludged pushrods]--burnt,bent,damaged valves---[loose,damaged rocker arms]--burnt,flat spot,sludged camshaft----sludge build up in engine-low oil pressure ---need oil ...
Question about 1997 Neon
...know about the pushrods and bent 3. Replace them and now it runs rough. Plug wires are correct, no vac leaks, or loose plugs. Could I have bent valves. You will have to adjust the valve
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
