Question about DCS6401 20 20",64cc Chainsaw 2 Cycle
...gas. Used it yesterday. Wont fire at all. Doesnt look like gas is getting to the plug. I did spray either into carb. Still did not fire up Check the start stop switch, sometimes they can get dirty ...
Question about GGX9868J Gas Dryer
...wont turn on again Hi there, this is motor failure. the actual motor windings are in bad condition at this moment. they are separating and this can ultimately start an electrical fire. the automatic ...
wont turn over. have new fuel filter and also do not see where old one is. is there anything i can do other than put gas in carborator to get it started I would pull the plugs and let the gas into the
...fire, and gas, oil but i dont know if maybe the compression is gone? If you have oil and gas and it will fire then try a new plug. A bad plug when removed will appear to be fine but under compression ...
Question about 25CC Gas BlowerVac
fire and gas still wont crank even if i put a little gas on sparkplug Pull cap check to make sure you are firing in seaquance you may need to put the number 1 up and check to see if the number 1 is is
...fire getting gas remove he air filter and drop some gas down the carb if it starts then it is in the fuelsystem if not check your plugs that they aer fireing rember gas fire timeing and ...
...gas but wont fire Are you certain it's getting gas, does it smell flooded? Pull one of the plugs, see if its wet after cranking. Ground plug and check for spark, if no spark, problem could be crank ...
...gas in it wont start sprayed either still wont start back fired caught fire at throttle body so has spark acts like it wants to but wont start did you pour some gas into the carb? hold your foot to ...
...gas and fire cranks but wont start I put new wires plugs rotor and cap it is getting gas and fire cranks over but wont start See if your getting spark,If not its probably the crank or cam
...fire remove plug and squirt a little gas in hole put plug back and try again Put in fresh gas. Make certain gas is getting into the cylinder. Change the spark plug and that it is firing. Start your ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions