Question about IS-LCDTV32 32 in. Television
...screen is black constant. PWR LED light on the front is Blue. Check for bad solder on convergence module. May have bad stk's. Do not neglect looking for bad solder on dsignal and defl boards. Some TV ...
Question about IS-LCDTV32 32 in. Television
...TV off and back on makes the picture return but it cuts outs after a minute or two. The power light stays blue and the screen still has power (dim glow visible in the dark the same as it does when it ...
...screen for a few seconds, and the TV blinks a red light (or the green power light). All the problems that cause this are an issue for warranty or extended warranty. you are not likely to spend the ...
...tv,tv screen stays black.what do yuo think? Plasma and LCD TV sets are prone to having capacitors in the power supply section fail. This is the most likely cause for the probem you describe. When ...
Question about NS-LCD37 37 in. LCD TV
...TV would kick in and the cable would boot up to watch. Now just sound from the cable and nothing was changed or unplugged. Most likely you have a fault in the back light circuit. To verify this, turn ...
Question about NS-LCD37 37 in. LCD TV
...screen - Slow start - Power LED on, but no picture - Unusual colors and/or lines The primary cause of LCD TV and monitor failure is caused by faulty capacitors. You can examine the capacitors in your ...
Question about NS-LCD37 37 in. LCD TV
...screen - Slow start - Power LED on, but no picture - Unusual colors and/or lines The primary cause of LCD TV and monitor failure is caused by faulty capacitors. You can examine the capacitors in your ...
Question about NS-LCD37 37 in. LCD TV
...screen while the TV is on. If you see movement then the Inverters are gone. If you don't get a dim picture then the T-con board is bad. You can get parts here: TV Parts Universal TV Stands DLP Chips ...
Question about NS-LCD37 37 in. LCD TV
TV has power but screen turns on once in a blue moon. Otherwise it just flashes very dimly when power button is pushed.Have to look at it from the correct angle to see the flashing. Red LED is on when
Question about NS-LCD37 37 in. LCD TV
...tv that the backlights went out. I am able to see an image albeit very dim but also noticed that after a little bit the screen image started pulsing. Do you have any idea why this would happen. Could ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions