...turn it on by pressing the play or record button. I can also record with it as well. I just cannot take snapshots--it powers down right away. Anyone else have this problem? I've only had the camera ...
...turn on after the warm-up period, try reinstalling the lamp again. Press enter on the projector or on the remote control to open the on-screen menu. Press the up ( ) or down ( ) arrow to select Setup ...
...Turn the box off for 10 seconds at the mains. 2. Reconnect the power supply and press the standby button on the front of the box until you see the amber light. 3. As soon as the amber light appears ...
...the "Next" button on the remote (the right arrow) until the red light on the remote turns back on. the LED on the receiver should turn from flashing green to solid green then back to flashing
Question about RemotePoint Navigator Remote Control
...right arrow button until the display says "System Configuration Menu" James Cowan: OK Earnest: Press and release the "OK" button James Cowan: OK and it says hardware failure status Earnest: Display ...
Question about RemotePoint Navigator Remote Control
...turn on orange light stays on and red and green light flashes and nothing else happens Every few minutes my DTI6300 160Mb box goes through the re-boot procedure (i.e. orange flash, three lights, then ...
Question about RemotePoint Navigator Remote Control
...turn on now.it stays on an amber light and doesnt want to do anything else.1day it was fine,now its not. Message taken from TopUpTV Does your Thomson DTi6300 fail to power on normally and displays a ...
Right Arrow button several times to select 'Print Test Page', and then press 'OK'. The test page prints. Tap 43 PRINTHEAD Health Diagnostics - See Video Procedure: http://inkjet411.com/?page_id=2377 1
...turn solid green (not in that exact order) and this is all normal. You will know when it is done when all lights are solid green and stop blinking and/or moving (except the INET & wireless lights ...
Question about X6v ADSL ModemWireless Router
...turn off, and stay off.
4. Press the blue button "TV" to make sure that the remote knows you want to use the remote for the TV.
5. Press the remote button "Input". ...
Usually answered in minutes!
1,383 Questions
1,133 Questions
959 Questions
944 Questions
808 Questions