Turns Off I have a pair of Cobra Microtalk that intermittenly shut off even when locked. Any suggestions? bad battery contacts
Question about microTALK LI6000-2 (14 Channels) 2-Way Radio
...Cobra MicroTalk radios will not turn on. I tried a good battery, but no luck with the obvious try. Your fuse is blown, not sure if you can replace it. Some of our radios you have to take quite a bit ...
Question about Microtalk 100 FRS Walkie Talkie Radios 2 Pack
...cobra microtalk walkie talkie & don't know how to turn on or use. I couldn't locate your specific model, but all of the Microtalk series radios seem to be basically the same as far as operations. ...
Question about Microtalk 100 FRS Walkie Talkie Radios 2 Pack
Cobra Microtalk walkie talkies Model #PR155. One works and the other one will not turn on. I bought new batteries for them and it stil will not come on. Where can I send them or take them to see if it
...talki. I don't know how to turn on or use. http://www.wedophones.com/Manuals/Cobra/FRS%20-%20GMRS%20microTALK%20Manuals/ Hi above is a link for you to download a manual, all is in there for
Question about Electronics microTALK® PR 3850 WX Two Way Radio
...turn off the beeping from cobra microtalk 2 way radio Press the menu button to scroll through the features. When it says "set roger beep on/off" press the up or down arrow to turn the roger beep off. ...
Question about microTALK LI6000-2 (14 Channels) 2-Way Radio
cobra PR 3150DX vibrates but will not turn on...any solutions? have switched batteries between units but one will only vibrate when turned on ... nothing appears on screen Probably best to trash and ...
Question about Electronics microTALK® PR 3850 WX Two Way Radio
how to turn off roger beep cobra microtalk cts 195 Support Cobra Electronics Corporation
Question about Microtalk Pr260 2 Way Radios Walkie Talkies
HOW TO TURN ON COBRA MICROTALK PR 260 WALKIE TALKIES you have to press & hold the "mode" button for a few seconds, same to shut them off
Question about Microtalk Pr260 2 Way Radios Walkie Talkies
...Cobra MicroTalk PR561 and one works fine but the other one will burn on but I can't turn it off nor can I change channels. Any ideas Try contacting Cobra directly: Support Cobra Electronics ...
Usually answered in minutes!
980 Questions
644 Questions
497 Questions
317 Questions
274 Questions