Questions & Answers for: tube buick 1994 start

buick lesare vents don't want to work all the time. i turn vent on it just comes out of defrost. i can be going down road and it will start coming out of the vents. the ac works same way. it works for

...Buick LeSabre for about a year. The car was doing fine up until recently when everytime I go to get in it in the morning it won't start and the security light comes on. I can't start it until it goes ...

...start & begin to begin driveing the temp light on my heater flashes for 2 or 3 minutes. The heater system works OK (the weather is to cold to check the AC) I'd like to fix this as I'm afraid it my ...

fine. Doesit moan all the time it's on or just as it starts. If it continues to moan then an orfice tube may be partly clogged. If just as it starts and goes away it's just the freon getting moving in

...start up again after it stalls, run for a bit, then stall again. It is a round filter in a canister. There is a tube that comes from the throttle body to the air filter housing. Loosen the clamp on ...

...start by removing the tubing near where it rusted through or leaks You go to the nearest original connection,a wheel cylinder,abs module etc. Then as you construct the tubing going back toward the ...

...tube and place it against something metal for a ground. Try to start the car and see if you see a blue spark. If you don't, you have no spark to your car and you need to check the ignition system. ...

...start.i change cps,plugs+wires,ignition controll module,mass air flow sensor,fuel filter.car still stalls what do i do next???? umm... They symptom you describe fits a couple of things that ...

...Buick road master just died on me and now it won't turn over I can ark it out on the starter but it won't stay running. What's wrong Theft-deterrent relay or module . Do you B+ voltage at the 10amp ...

...buick roadmaster started Lt1 motor Into the throttle plate , Look at round black rubber tube from air filter box over to the engine ! Use a screw driver , loosen the clamp and pull the hose off the ...