Questions & Answers for: truck dies brakes applyed

truck dies when brakes applied i have a 97 dodge truck 2500 4x4 When i brake or let off gas it dies it has a360 for motor but it will start up & do it again You have a big vacuum leak,,check all ...

Truck dies suddenly Hello, I have a 2003 Dodge Durango. Fixed air leak, replaced camshaft sensor, and replaced the map sensor, but my truck still dies when i come to a stop. It cranks right back up & ...

...dies when you have your foot on the brakes, then it's probably a vacuum leak on your brake master cylinder, It is a large hose running from back of intake to brake booster, with a plastic fitting for ...

truck dies when applyting brakes truck dies when applying brakes possible that the brake booster is leaking. Check when you press the brakes if there is a hissing sound under the dash near your brake ...

dies when you take your foot off the gas and apply the brake. To keep the truck from dying you have to peddle the vehicle like a bicycle when coming to a stop. Hold gas peddle down to keep engine from

...Truck Battery died and was replaced Still wouldn't start so the Starter and the Alternator were replaced. (All in the same week.)Now when I turn on my headlamps my brake lights don't wo There was a ...

why does 4runner quit when brake is applied Was running fine then applied brake and car died. Will start back but dies again when brake is applied. your tps is out of adjustment I think there are some

tercel 95 motor dies when itouch break what possibility is run the motor and just use the hand brake if it runs ok then apply the foot brake and if it dies then the brake booster is suspect as it is ...

i have a 2001 dodge dakota 4x4 crewcab with a v6 every time i come to a stop it dies do you no y it it idles ok with the hand brake on but dies when the foot brake applied , replace the brake booster ...

...brakes the car dies. It died 3 times while at McDonald's drive thru... Sounds like all the vacuum is being taken away from the engine by the brake booster. This would indicate a faulty vacuum valve ...