Questions & Answers for: troy bilt lawn mower repair

...Troy Bilt 860 Self Propelled mower. I has been squeeking and today the self propulsion stopped working, it is cutting and can be manually pushed. My nearest Repair centre is 25 miles away. It it ...

Troy bilt lawn mower. Will not engage self propell, front wheels The handle that I normally grasp to engage the self propell has no tension. I checked the handle and everything is hooked up fine there

...Troy-Bilt Pony riding lawn mower as well.  If yours is like ours, a model 13AN77TG766 [URL:http://manuals.mtdproducts.com/mtd/DocGetter?doc=769-02243a.pdf], it doesn't actually have gears but ...

Self Propelled mower quit self propelling After running the left wheel into a wall, my self propel doesnt work anymore. I have pulled the cover off and see that the cable for the self propel was ...

Troy Bilt Lawn mower manual some fixya user told me a website reliablestore it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and ...

...Troy Bilt Snowblower. My father ran over a large extension cord while blowing snow, which in turned wrapped the cord around the auger shaft ends. I can now only get one side of the auger to turn. Is ...

Troy-Bilt lawn tractor (42 in/ 18.5hp), problem is when I put it in forward it does not engage. I think it is the drive belt, which is very loose and worn. Any thoughts find a small engine repair shop

...troy built 21" rear wheel drive push mower. My problem is that it will not drive its self. I pick up the back end and the wheels take off no problem. But when I put it on the ground it does not ...

...troy bilt 42 inch 17 hp lawn tractor. The problem is when I cut grass and i get in some thicker grass the blades turn off then I back out the blades restart. The engine never bogs down One or more of ...

troy bilt mower pony why it dies in reverse runs fine in neutral or forward? are your blades engaged when you try to do this?? if so it is a back up safety feature from factory,turn blades off and try