Questions & Answers for: troy bilt engine start choke

troy bilt tiller I can get my tiller to start in choke mode but when I switch it to run it cuts off every time. either the carb needs cleaned or theres a vacuum leak

engine. After pumping the choke bulb on the carb, it will crank, run maybe 5 seconds and quit. Thanks When you get it started, move the choke to the middle, then let it warm up. you might have to move

Troy-Bilt Mower - Model 834. It has a Honda GVC 160cc engine. It is supposed to start after two pulls when cold and did so since I bought it in 2006. But, just recently it takes 6-10 pulls to start it

...engine the choke is used only to start the engine. If you unit is newer and still does not run well with the choke in the open position, you may need to adjust the hi-speed circuit to a richer

...Troy Bilt Tiller make sure there is fuel and oil in the engine. There should either be a choke lever/setting or a primer bulb. Push the primer bulb, if there is one, or choke the engine. Make sure it ...

...troy-bilt tiller TB146 EC that is less than one year old. I cannot start it. Before it stopped operating, I observed the following: (1) I saw smoke is coming out from engine. I think engine oil is ...

...troy bilt pony with a 6hp Tecumseh engine. It's difficult to start and when I get it started I have to leave the choke on or it will die. Also it doesn't run as it should. I drained the old ...

troy bilt sequall 2100 will not start. has new plug Has new plug and turns over fine. new gas.??? Is the gas making it TO the new plug? Pull it over a dozen or so times on full choke and then pull the

...Troy-bilt rotor tiller? It takes a few pulls to start. After it starts, it must stay on full choke to run. It then surges the whole time, and dies after a minute or so. It has fresh gas and I have ...

...Troy-Bilt Colt Ft Garden /Tiller 208CC Model No. 21B-34M8711 Hey there! All you need to do is... 1. Locate the engine control panel. You'll typically find it on the top of the tiller's engine. Look ...