Question about 9100 Next Generation Remanufactured Treadmill
treadmill does nothing. Nothing appears or lights up on the front console. I removed the motor cover and peered into the motor controller (part number AK58-00146-0004). When I turn on the power switch
...treadmill that has worked perfectly until now, when it shut down displaying a E1 error message...any ideas on what to do? Thanks :) E1 Is an RPM sensor error message. It simply means either the belt ...
Question about Acd1 Treadmill Motor Control Board 141877
...treadmill will sometimes start and most times will not, even though there is still power. Then I will be on and the belt will stop turning. I can move the incline level but that is all. Hello, With ...
Question about Acd1 Treadmill Motor Control Board 141877
...treadmill malfunction. Here is a list of each LED and what it signifies: MOTOR (yellow) - The MOTOR LED illuminates when dc (direct current) voltage is sent to the drive motor. The LED gets brighter ...
Treadmill will not go over 0.4 MPH. Loosened belt and no change. Completed the steps below without any change; MC-2100 Motor Controlled LED's Off - When Power is off Solid - When Power is On, with
mc 2000 es after many seconds motor off but pwm led flashed. please see the video attached. and lube too the rollers bearing front+back. Test the drive belt motor fro crack, tight or replace it. Test ...
error code e11 hi 1.Check that the LED light flashes on the motor controller while rotating the flywheel, check the connections on the controller and control panel.
Question about 9100 Next Generation Remanufactured Treadmill
...Led #1 is not flashing. motor controller board has error comunicating with console, you can try to disconnect all leads connecting to console and reseat. failing that you would need to send off board ...
Question about 9100 Next Generation Remanufactured Treadmill
...treadmill - the speed and time are not working - led is fine but does not show time or speed just random numbers flash...how do I fix this?? Sounds llike you may have problem with your speed control ...
Question about 9100 Next Generation Remanufactured Treadmill
treadmill belt is not moving. The led still blinks when I disconnect the speed sensor/reed switch. When I power the TM on it beeps a few times the the led begins to blink ,but no lights on the display
Usually answered in minutes!
346 Questions
191 Questions
188 Questions
214 Questions
122 Questions