Questions & Answers for: toyota yaris 2007 check engine

...temp light comes on when i start then turns off. 2007 toyota yaris sounds like a bad sensor first check to make sure that your coolant level is ok if it is then its probably the sensor going

Ad

Question about 2007 Yaris

1 Answer

...toyota yaris I need the writen manual for toyota yaris 2008 for the user gide and engine check and ather check I have seen one for 2007 yaris in PDF format. It should hopefully help you a bit. Google ...

Ad

on toyota 2007 yaris starts then turns off after engine detailing- check engine tight turns on and the car stalls, there is no display of the speedometer either Pull the code and post it here.

Question about 2007 Yaris

1 Answer

...toyota yaris 2006 Error Code: P0500 Fault : Vehicle Speed Sensor (VSS) - Circuit Malfunction Possible Cause: 1. Wiring harness. 2. Vehicle speed sensor (VSS). 3. Engine control module (ECM). 4. ...

Question about 2007 Yaris

1 Answer

2007 toyota yaris srs light srs light came on how do you turn it off Pull up the error codes after which you would be able to repair the defect.

Question about 2007 Yaris

1 Answer

...check engine light on n give me this code p 1589 The P1589 means Autolamp Delay Increase Circuit Short To Battery. you can erase the fault code with your obd2 scanner first, after then, if the check ...

...toyota yaris car and the following codes were give ; temperature ckt low input po117 my car toyota yaris stall wile on motion and i went to scan it. the following codes were give po117; po340; po500 ...

...Toyota Yaris, Toyota Camry, Toyota Tundra, Toyota RAV-4. Before replacing the sensor you should try cleaning the sensor gear and erasing the code. If the light comes back you may have to replace the ...

...red light/at green car went into limp mode...parked it and notice slip indicator is lit also/scanned and got code p0705. You got the code Go to the internet (Google) Type: 2007 Toyota Yaris OBD ...

...Toyota Yaris doesn't want to start. The starter is turning but the engine is not firing?? I checked the crankshaft pulley and the screw was loose. Basically the pulley was wobbling. What might be the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...