Question about 1996 Sable
...96 sable is underneath the dash (where the fuse box is) and that I would just have to lower the ecu and swap it out with the new part. Then I'm assuming I'd just need to clear or reset the ...
...clicking sound, the radio and lights turn on. Place jumper cables on the battery and connect to another vehicle. It should start (and identifies that your battery is very weak in reserve
Question about 1996 Escort 4 Door
...96 escort, my battery is dead after only a few hours however when the car is running (after jump starting it) the immobilisor light comes on for about a minute, then starts to flash every 3 seconds. ...
what is the size of battery for 1997 ford escort hi, according to the interstate battery chart we use, the 97 escort uses only group size 58 battery, 98-2004 take group size 35, as does 93-96.
...touch battery while touching both hot -n- ground together for a few seconds. Then put the hot/red cable back on the battery-tighten. Then put on the ground to the - side of battery. Start your car- ...
...ford escort by unpluging it? There really is not (resetting) the computer, but you can erase the engine codes by unhooking the positive batter cable from the battery and touching it to the negative ...
How to reset PCM box on a 2005 ford 500 Take Ground cable off battery wait 20 minutes then put cable back on. It would be the same as clearing computer codes. You just resetting PCM..
Question about 1996 Mustang
battery cables and touching the cable ends is all you need to do . And 10 min. is all the longer you need . How To Clear Your PCM Memory On Fords After Repairs This works for all vehicles with control
Question about 2004 Silverado
...the battery cables an touch them together or a jump wire between the cable ends . Let it hooked up 10 min. How To Clear Your PCM Memory On Fords After Repairs You don't need to bother with the ...
...escort zx2 Well the computer on any car can be reset by removing the positive lead of the battery and touching it to the frame or negative post if it will reach. Be careful not to short the wrench to ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions