Questions & Answers for: torque tension pulley taurus

...pulley on What it the torque specification for the belt tensioner pulley on a 2000 ford taurus? call your local ford dealer ask for service talk to a mech ohr go to the library and look in auto ...

Ad

...bolt and the nut. Install the water pump pulley. Install the accessory drive belt. Connect the battery ground cable. Fill the engine cooling system. Water pump bolt torque sequence (3.0L (2V)

Ad

Question about 1999 Taurus

1 Answer

...pulley face must be flush within 0.010 inch (0.25mm) of the pump shaft. Install the power steering pump/pump support and torque nuts/bolt to 24 ft. lbs. (33 Nm). Install the bracket mounting bolt ...

Question about 2002 Taurus

1 Answer

...bolt and the nut. Install the water pump pulley. Install the accessory drive belt. Connect the battery ground cable. Fill the engine cooling system. Water pump bolt torque sequence (3.0L (2V)

...pulley will either move up or down. when I used to wrench on Ford Tauri I would grab the belt on the exposed portion on top and pull upwards, this collapses the tensioner. I would jam a long ...

...torque specifications for replacing pullies on the tensioner and idler on a 2003 ford taurus with OHV(12 valve) engine? 15 mm idler pulley bearing bolt: 18 to 22 lb.-ft. 35 lb -ft on the tensioner ...

...pulley face must be flush within 0.010 inch (0.25mm) of the pump shaft. Install the power steering pump/pump support and torque nuts/bolt to 24 ft. lbs. (33 Nm). Install the bracket mounting bolt ...

...tension, then tighten the adjusting arm and pivot bolts. 3.0L SHO Engine ALTERNATOR BELT See Figure 2 Loosen the nut in the center of the idler pulley. Loosen the idler adjusting screw until the old ...

Question about 2003 Taurus

1 Answer

tension on the accessory drive belt so that you can remove the drive belt from the pulley.Take off the mounting bolt on the right side of the alternator with a socket wrench and remove the bracket for

...tension on the accessory drive belt so that you can remove the drive belt from the pulley.3Take off the mounting bolt on the right side of the alternator with a socket wrench and remove the bracket ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...