...torque converter? Its possible it could be other things causing the problem, but seeing as you've checked most of the likely causes, it is most likely your Torque-Converter. The lockup clutch in your ...
...torque converter would move out from transmission slightly, and cause similar problem. used to have to rotate torque converter, while pushing in toward transmission, and suddenly when in the right ...
...torque converter is good and all but when i go and tighten the bolts to the transmission the egien locks what could it be at first we thought it was the spline didnt go in the torque converter but we ...
...torque converter was properly seated on the input shaft of the transmission. In oder to do this you need to spin the torque converter and push it into the transmission so as to spline the torque ...
...torque converter with the transmission you purchased. most times torque converter has to be matched especially with a used transmission.also need to make sure torque converter filled properly with ...
torque converter.A torque converter shudder is a brief shake or shudder in the vehicle when internal clutches apply inside the torque converter. They refer to this application of clutches as "lock-up.
torque converter till the torque converter with a quarter what tranny fluid Road in the room so the gears get fluid to then installed a new flywheel reinstall the transmission installed the driveshaft
Question about 1997 Expedition
...torque converter onto the shaft of the transmission first and push it all the way back to engage the oil pump for the transmission install the transmission then pull the torque converter forward to ...
Question about 2011 Grand Caravan
...torque converter malfunction Possible causes Low or dirty transmission fluid Faulty torque converter clutch solenoid valve Torque converter clutch solenoid valve harness is open or shorted Torque ...
Question about 2011 Grand Caravan
torque converter assembly ( pump drive not in alignment) remove the torque converter from the flex plate and install properly onto the input shaft then fit the transmission to the engine then pull the
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions