Questions & Answers for: toro leave blower working

Toro saves $15/mower as well as selling new Z4200 starters. Did you fix it? Happened to me and what I found out on top of fuel tank there is a brass fitting that goes into the tank. The fuel is picked

toro 2 stroke lawn mower won't start I half filled it with gas mix, replaced spark plug ( old one very dirty), and checked the air filter. It still won't turn over. Remove the Carb Bowl and on the ...

...toro 6.0 lawn mower wont work i just took it out from the shed, it was in there during the winter and now wont work. it worked perfect before why is this not working someone told me its debris in the ...

...Toro lawn mower it start good but will not keep runing what can I do Does the fuel line have a filter? It sounds like the float in the carburetor is running out of gas. Sludge builds up and the ...

have a 51970A weed wacker that won't run. need scematic for fuel line not in owners manuel The longest, and sometimes smaller in diameter of the two fuel lines, goes from the carburetor to the bottom ...

...Toro stops. It doesn't act like it is running out of gas, it just stops suddenly. I have done what "mrfixxit-jerr" had mentioned but nothing. If I leave it for awhile it will start again but only go ...

...blower to vac. Toro 850 super blower/vac Hi, Remove the air inlet guard on the bottom by pressing the release and pulling down on the guard. It will tilt off. Remove the blower pipe from the front of ...

...blower.Remove the air box cover, air filter, and air box back plate. Careful there is a gasket on the back of the backplate that if damaged the primer bulb wont work, part # 272653.  Remove the ...

...toro 6.0 magnito The ignition module is bolted to the front of the flywheel. Im going to assume this is a pushmower and not a leaf blower... Remove the plastic top cover, remove the fuel tank, ...

...toro dealer just worked on two weeks ago adjust fuel screw turn it one turn out see if that gets it running if dose turn it slowly in until throttle runs smooth the screw to adjust is the h screw on ...