Question about Lawn Mower With Toro Power Tools
My Toro Model 20017 self propelled lawn mower will not shut off. What part needs to be replaced? The wire from the coil to the kill switch may be disconnected
Question about Lawn Mower With Toro Power Tools
...Toro 20018 mower. It would not start without disconnecting green "kill" wire. Now what do I need to do - replace the kill switch? Is the kill switch located on the lower right base of engine? It is a ...
Toro self-propelled mower will not start. I thik it is the kill switch. What can I do now? Can I bypass? Yes you can just unhook the wire and see if you have spark then, only thing is if it is the ...
...toro 5.5 gts so I can replace the kill switch mech under it. Not sure what you mean by "Kill Switch", but you should not need to remove the flywheel for any reason, except to replace the timing key. ...
Question about Power Lawn Mower
...Toro groundsmaster 120 engine kills when engaging blades at switc. Clutch? clutch sounds like a bad safety switch on the drive system unplug wire form temp sensor on right side of engine and ...
Question about Power Lawn Mower
...not start unless i disconect the kill wire on the coil Sounds like a stuck kill switch. Try flushing out the kill switch with some fluid under pressure like WD-40 till you can feel or hear it
...toro z5060 mower turn off after starting? I replaced the starter switch but that did not solve the problem. Where is the kill switch located? Right on the throttle linkage,look for wire that connects ...
Question about Power Lawn Mower
why does my toro model 74624 kill when i move the leavers in mode 74624 blade safty switch is bad or neutral safty switch bad
Question about Power Lawn Mower
toro up and lower the hand break then it switch off safety switch malfunction possibly ZTR mowers will kill the engine if the operator seat is not occupied and the brake is released. Likely you have a
Toro Timemaster 30 self-propelled mower. After conducting off-season maintenance, it started right up, but would only shut down by pulling the spark connector. I replaced both the kill switch and coil
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions