...axle feels loose on the transaxle side of shaft on both sides. Does this mean that the CV joints are bad? Take it to you dealer it is under warranty and have it checked out. The noise could be cv ...
...axle feels loose on the transaxle side of shaft on both sides. Does this mean that the CV joints are bad? I Have 2006 HHR ,Hear a rubbing noise that changes with my speed sounds like driveshaft or ...
tools are needed to chang rear cv joint in a 2002 mercury mountaineer Basic tools..remove wheel, remove axle nut, remove brake caliper, remove lower control arm bolts,remove the bolt for upper control
...cv joint HHR remove hub cap, loosen axle nut before lifting up, remove tire an lower ball joint, remove axle nut knock it loose, remove from wheel hub, use axle puller and pop from transmission. ...
...change the CV (constant velocity) axles on a 2010 Dodge Avenger with a 4-cylinder engine, you will need to follow these steps: Gather the necessary tools and materials. You will need a jack and jack ...
tools are needed plus a large socket for the axle nut. https://www.youtube.com/watch?v=qD4arlr9jag http://www.fixya.com/cars/t17796741-right_side_cv_axle_replacement_hhr Also a post about cv questions
...CV axle n still popping 2007 Chevy HHR LS AUTO TRANS. FRONT PASSENGER SIDE HALF SHAFT CV AXLE REPLACEMENT. STILL POPPING?? WHY?? SHOULDNT NEW AXLE HAVE CAME WITH INNER TRANSAXLE SPLINE INTACT?? did ...
...CV Axle Assembly, Chevrolet Cavalier Drive Axles, API CV Axle Assembly, API Drive Axles SKU: API 1700197008, API 3158-07726494 CV Axle Assembly -- Pass. Side Axle Has Stub Shaft Inserted Into The ...
Question about 2010 Avenger
...tools you might require for this job: Jack and Jack Stands: Used to lift the vehicle safely and provide support during the repair. Wheel Chocks: Ensures that the vehicle stays in place while lifting ...
Question about 2010 Avenger
...sockets are needed to replace the front passenger cv axle on a 2001 Chevy venture? To replace the front passenger CV axle on a 2001 Chevy Venture, you will need a 32mm socket. That's what I've
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions