Questions & Answers for: tire wear rear cupping

tire shows visible signs of wear to the point of replacement at only 5000 mi., my buddy has a 8-ball with 1000 more miles and less wear, same roads and driving conditions, would it have anything to do

...tire wear in rear causes a very similar noiselike rear bearings,if ok sounds like another bad bearing possibly caused by poor installation i see this alot,also check to see if brackets that attach ...

...wear out extremly fast cupping on the inside rear tires mainly why? Sounds like the tracking is out. Tire cupping, high and low spots on the tread pattern, is the result of alighnment or suspension ...

How do i know if i need a four wheel alignment or 2 wheel Most front wheel drive cars are good with a front end alignment. You can go by how the tires are wearing. If the rears have been on there for ...

...and especially not both at the same time. I have also never had a bearing cause a tire wear issue. i dont know or cant see the ware pattern on your tires but as an alignment tech have aignment ...

...and rear tire pressure. Regardless, I have found that running 35 pounds front and rear promotes even as well as longer tire wear. The ride may be harder but you also get less cupping on the

...gives you Honda's recomended tire pressure. I like to run a higher pressure 35-36 PSI front and rear. It gives a stiffer ride but also helps cornering and makes for more even tire wear (less

...uneven wear from inside to outside of tire. The shop should supply you with a printout of where your measurements are currently and what they should be. Can you send a good picture of the tires

tire wear 2011 hyundai elantra original tires bald on rear at 24,000 mile. rotation per manual. new tires with 40k miloe waranty wore out at 19,000 miles. rotated per manual. Another new set with ...

...rear end of the car.thought maybe lugnuts were loose but were tight when i checked.i noticed that both sides of back tires are leaning out at the bottom side.could it just need an alignment or ...