Questions & Answers for: timing wire 1992 s10

...1992 Chevy S10 4.3, it will not start....there is power going to it all the lights come on and the radio ... etc.... but it just wont start...there is no click ...no thing...i checked the wire that ...

...timing wire follow the directions on that label otherwise if your using a timing light and trying to set the timing it will be off dramatically due to the etc (electronic timing control) depending on ...

...wire and is tan with a black stripe.unplug at the connector.now you can check the timing. it should be 0 tdc You can find out online. Use wahtever search engine you want and just type in 92 S10 ...

...wire to the electronic timing control. Re-start the vehicle and the check-engine light should go out, that is of course if it was not already on before because of another problem. You can re-set the ...

...1992 s10 Blazer, I changed plugs, wires, cap, rotor, and fuel filter. Then after I had it running again I sprayed carb cleaner in the carb to clean it. It ran perfectly for 2 days and now it won't ...

1992 chevy S10 4.3, when it is damp out the engine skips like it is out of gas... one time it would not start at all.. the weather changes and it runs fine..new gas tank and fuel pump etc 4 years ago.

...and zero is top dead center correct?? Here is a picture for you. Zero is Top Dead Center, but If I remember right you have to disconnect a wire in the cab under the glovebox when you set the

i have a 92 chevy s10 4.3, and i cant figure out how to make my instroment cluster work.. ive replaced it 3 times but nothing. any ideas? I think it may be coming from the wiring harness behind the ...

...1992 S10. 2.8 V6 The temperature gauge on the dashboard is not working. It is on the very bottom all the times. The speedometer works intermitent. check if the wire and the connector on the ...

...1992 chevy S10 ,2.8 locate the tan wire with black stripe under the dash on the passenger side it should be taped to the harness unplug the inline connector and esc will be disabled for setting the ...