...is not aligned. I removed it yesterday to do some other repairs. determine cylinder number 1, set timing marks to Top Dead Center compression stroke for number 1 cylinder, with all marks properly ...
...timing mark on the balancer must be at TDC. Then when you put the pump in, the rotoe should point in the direction of #1 cylinder. If you know that you had these things in order, you probably need to ...
Question about 2000 Frontier
...frontier 2wd pick up truck? I cant seem to find the drain bolt on tranny, does the pan need to b dropped or am I just not seeing the drain bolt? what tranny fluid should I use and how much should I ...
mark on the spindle with the hole in the oil pump as shown. Install or connect the following: Oil pump and drive spindle. Tighten the mounting bolts to 96-132 inch lbs. (11-15 Nm).reverse procedure on
mark the location of the rotor in relation to the distributors body and side of the engine and install the new distributor with the rotor pointing in the same direction as the original. You'll need to
Question about 2000 Frontier
...frontier SC, 69000 miles. Motor runs well when first start the engine and runs very routh after warm up and it just stops sudenly the engine. Three codes P0328(knock sensor 1 circ i had some sensors ...
Question about 2000 Frontier
...timing is right. All line on the new belt match maks on the gears and I have 40 teeth between the cam gear mark and 43 between the LH cam gear mark and the crank gear. ?? Nissan markets its D22 and ...
...frontier wont start... Replaced distributor n timing belt If it's the timing belt you may have it a tooth or two out. Take the cover off and turn the engine till the timing marks are on and see if ...
...situations. you can find information on how to change the timing belt/set timing in the repair manual (check link for navara aka frontier) Nissan Navara Service Manual 1997 2005 Service Repair ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions