Questions & Answers for: Subaru timing mark

...timing mark (small hole) on the camshaft gear aligns with the mark on the plastic cover behind it. Mark is on top of plastic cover (12 'o' clock). Rotate the crank till the timing mark (groove, not ...

...teeth good luck. (2) While aligning alignment mark on timing belt with marks on sprockets, position timing belt properly. NOTE: Ensure belt's rotating direction is correct. Timing Mark Alignment ...

...timing marks for a cam belt Ej-25 motor has 4 cams. Cam sprockets are marked as follows. Intakes have single hatch mark which point straight up and a double hatch mark that face straight down at ...

Timing mark locations on EJ22 subaru engine putting timing belt on 1991 2.2 litre subaru liberty that didn't have any on it,just want to know where the marks are? Complete instructions including ...

...timing mark on the fllywheel it has to be set to and it is not zero or top dead center....look for special marks on the flywheel thru the rubber inspection slot in the back which is quite a few ...

...in the same area of the timing marks about 50 degrees or so from the timing marks. Turn crank until you identify these,then use the center mark of the 3 for your crank position on belt

...mark on the engine block aswell> pluss the new timing belt will have white marks on it that will line up with all of the marks on the pulleys when they are in the right place so its nearly ...

...timing mark on the crankshaft sprocket (1), left intake sprocket (2), left exhaust sprocket (3), right intake sprocket (4) and right exhaust sprocket (5) with the notches in cylinder block and timing ...

...timing marks on it, they come in real handy, clamp the cams so they don't retract, before pulling the belt, put a pin in the belt tensioner hole if it has one, then pull the belt off, align all the ...

...timing mark is on zero.the cam belt pully should be lined up with its own mark.number one piston should be at the top of its stroke (top dead centre TDC) and number one valves should be shut. if the ...