Questions & Answers for: timing mark

Ad

Question about 2000 Sportage

1 Answer

...align the left cam pulley ?I? mark and the right cam pulley on the ?E? mark. WARNING When aligning the timing marks, do not turn the timing gear counterclockwise. Damage to the engine will

Ad

...timing belt pulley mark with the mark on the engine block. Fig. 1: Timing marks are located on the camshaft pulleys as shown-1.8L engines Fig. 2: Make sure that the crankshaft sprocket (timing belt ...

Ad

Question about Motor 1996 Elantra

1 Answer

...Nm 7 is timing mark on cam,pin mark to top,hole in spoke below pin mark lines up with mark on head 6 is crank timing mark,pin mark on crank lines up with mark on block NOTE this mark is just before ...

Question about Motor 1996 Elantra

1 Answer

...timing mark is at the 12 o'clock position. Rotate the right camshaft until the timing mark is at the 11 o'clock position. Position the crankshaft using the special tool. Then remove the tool. ...

Question about Motor 1996 Elantra

1 Answer

...timing mark. The next mark is the BTC timing mark. the third mark is the TDC mark. Set the points to .015 gap then use a timing light while rotating the base plate to line up the BTC mark at idle ...

Question about 1996 Camry

2 Answers

...MARK ON TOP BOTH GEAR SPROCKETS ON CAMSHAFTS TIMING MARKS SHOULD BE IN THE 12 OCLOCK POSITION BOTH CAMSHAFT TIMING MARKS SHOULD BE LINED UP WITH TIMING MARKS REAR OF TIMING MARKS ON TOP OF CAMSHAFT ...

...timing mark, on your lower timing cover has some timing marks - crankshaft should be on the 0 mark. Camshaft timing marks--intake camshaft mark set at 3 o'clock and exhaust camshaft mark set a 9 ...

...elantra 2009 4 cyl. valve timing, crank pulley T D C mark to mark on timing cover. Cam gear mark to mark on head or block . Ignition timing T D C mark on crank pulley to timing mark on timing

...mark on the timing belt lower cover. With the crankshaft pulley being aligned with the 0 mark on the timing belt cover, the hole on the camshaft sprocket should exactly be in front of the notch of ...

...timing mark to 0 on the timing chain cover by rotating the crankshaft clockwise. B. Verify the timing marks on the camshaft timing gears are in general alignment with the timing marks of the camshaft ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

21120 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...