my 8n tractor is hard to start. I have to crank for a long time. when it finally starts it is very slow to warm up with out choke on. well mine is the same way but all old traktors r like that
Question about 8n,9n,2n, Tractor Starter With Drive
...Ford 8n, it gets hot after about 2o minutes of use. Have replace everything but the whole tractor,I was told it was the timing.Have done this on a 1965 mustang back in the day. How is it done on this ...
Question about 8n,9n,2n, Tractor Starter With Drive
Ford 8N has a broken tooth/teeth on ring gear. How Ford 8N has a broken tooth/teeth on ring gear and a times starter just spins. I rock tractor in gear to move ring gear. How far do I have to split ...
8n ford backfiring through carb Engine is either out of time, or plug wires are crossed to wrong plug. Firing order should be 1, 2, 4, 3 If you need new plug wires or timing gears, try www.Ford8n.com
Question about 8n,9n,2n, Tractor Starter With Drive
...Tom Yanick You just go to the link I attached I'm sure you will get the solution of your problem- ...
Question about Tractor 8n Front Emblem
8n Runs for short time perfectly. Then abruptly quits. Carb works good after full clean, float valve seated,Venturi changed. No longer flooded. New coil changed. Points next? have you changed the ...
Question about 8n,9n,2n, Tractor Starter With Drive
Ford 8n Is It Time to Replace the Starter? I have been through and cleaned all of the wires for possible bad ground. I took the starter apart and saw no visible signs of erosion or damage. When you ...
...timing on 8n ford tractor!! Does it have points? Use a 12V. test light on the dirstibutor terminal to + side of coil. When the test light goes ON,that is the timing at the crackshaft. Just like the ...
Cannot turn distributor by hand on a 1950 ford 8n I am trying to time my ford 8n but the distributor won't turn by hand. I did loosen the hold down clamp. It is frozen, hit it with a soft faced hammer
Question about Tractor Model 8N Operators Manual 1948-1952
Ford 8N Tractor? This 8N has front drive hydraulics, and there a shaft in the way. answered:- There is a coupler on the driven shaft. Take out bolts and gently pry apart. This should allow enough room
Usually answered in minutes!
843 Questions
243 Questions
163 Questions
186 Questions
140 Questions