Questions & Answers for: tiller won 39 move

...won,t move, power at the tiller is good, but sometimes won,t go. When this happens, I get no clicking sound when I try move. This only happens once in a while, but I,m stuck untill it decides to go ...

...won't turn. The belt is fine and pulleys turn but the tines do not. Are there shear pins or anything that would prevent tines from turning. Any suggestions? Yes, there are shear pins on the tines ...

...gas makes it a mechanical problem ? I would think that it just won't start. Hi, By not adding oil to gas you have distoyed the tiller. The oil lubricates the moving parts in the engine. Good ...

...tiller tines won't move engine runs fine tiller starts but when i engage blades eng stalls. tines frozen won't turn then you need to open the gear box and find out why if it has a forward ...

...tiller and is a separate pot from the engager. is set to zero ohms. At the controller output to the motor use the meter to take the DC Voltage measurement. Pull the engager lever to full forward. The ...

...won't move! i turn the key, plenty of battery power, all lights, horn etc working but will not move forwards or backwards, when i pull the controls all i get is a beep. any thoughts? Either ...

...won't move. Battery charger shows a full charge and charge gauge needle shows full charge.The horn works The power eye was flashing a code of "5", so the netural lever was put into ...

...won't move with charged batterys Hi, any bleeping, flashing lights , double check the freewheel lever,1. Any clicking from the rear .Please keep me updated.Regards Sounds like the freewheel ...

tiller won't start Tiller hit a rock ..engine quit....unable to restart. Starter rope is difficult(not impossible) to pull. Removed cover to see if flywheel was loose. Flywheel is TIGHT on shaft..

...tiller won't stay running I can get to tiller to start by spraying a quick start spray to the carb intake area. It runs for 30 seconds, then stops. I have drained the old gas from the tank. Add ...