touring rear wheel FIRST reinstall the brake disc in its original orientation if it was removed and tighten the fasteners alternatively to 30-45 ft-lbs (41-61 Nm), ensure that the compensator sprocket
...tighten lights atatched to blinker light so you want to tighten your own front signal on an FL model with spot lights. You'll need to remove the turn signal from the mount below the spot lamp by ...
...the potential fixes for them. IMPORTANT if this is an EFI bike unplug the ECM fuse before charging, tightening, and or removing connections to the battery. There is a small chance that you could ...
...lights up. How do I replace or check the fuel level sender? Use the following as a template fro how to get at the fuel sender: The fuel pump pressurizes the fuel rail/line to a high pressure in the ...
Question about 2008 FLHR Road king
...handlebar and the lower switch housing, start the upper and lower switch housing screws but do not tighten them at this point, verify that the wire harness conduit runs in the depression at bottom
Usually answered in minutes!
180 Questions
151 Questions
96 Questions
21 Questions
15 Questions
