Questions & Answers for: Nissan tighten lights

...tighten the bases of the light bulbs on the back of the instrument cluster. when i fixed the light, out of curiosity, i checked all the lights on the cluster. Indeed, quite a few of them were kinda ...

...just clicks lights come on dash lights up new battery try this ...turn on lights and try to start...do the lights dim?.... yes? replace starter,,,,and be sure to clean/ tighten ground from battery ...

...moves away from pedal. leave some clearance, very slight, between plunger & where it makes contact. Then tighten both nuts to keep it in place.Not too much clearance, just enough that lights go

a loose connection at your battery or the distribution block. This is normally the ground wire. Try tightening these connections and you should not have a problem. Or wiggle the wires

...Pontiac Tighten your terminals and test your starter. My 2006 Nissan won't turn over. inside overhead lights work, but head lights or engin will not turn on. battery is charged. What could be ...

belts How do you tighten the belt for the generator? Is the light coming on or belt squealing? If the light is coming on then the alternator is going out. The belt can't be tightened. You have a ...

...pedal and keep it pressed. Open the bleed screw half a turn to release the air and then lightly re-tighten the bleed screw . Ask for the pedal to be released then depressed fully again and held

tighten the connection in my head lights? sometimes when i slam my hood closed, the passenger side head light goes out. what's that about? i feel like it should be simple. a similar issue was resolved

engine light staying on the engine light staying on Try tightening the gas cap. If this doesn't fix the problem you need to take it to a mechanic or dealer that can read the error code that is causing

...fuses and they are good after each step below check for power: 1. make sure you have a good ground. tighten battery negative if loose (also at the other end of the cable.) (tighten also the b+ if ...