Questions & Answers for: tighten door hinges

...door. Then tighten the hinge again. Sagging may also be caused by a wrongly placed shim. In this case, you can correct the problem by removing the shim. Experiment with the shims; you may be able to ...

...Door Problem - doesn't close at top We had the hinges replaced; worked for a few weeks, now the same. Cannot even clean oven - door will not lock ! We read the 'hinge/screw tightening' solution, but ...

...the door a few times, then you didn't tighten down the hinge mounting bolts enough and will have to go through the adjust procedure again making sure to tighten things up better the 2nd time

the front door and body. Install the retaining bolts. Tighten to 25-35 Nm (18-26 lb-ft). Adjust the front door and front door upper hinge and front door lower hinge as outlined, and remove the support

...door is sprung and needs to be replaced or straightened tighten the screws in the hinges and if there tight? then the door is sprung and needs to be replaced or straightened If the door is sprung how ...

...firmly to the microwave, tighten the door hinge. Replace the top hinge. (On some units, both hinges need to be installed at the same time. Use masking tape to hold the lower hinge - makes it

...like a little round washer type is broken or missing replace --needs realignment loosen top hinge and close door and adjust till door is straight and stays closed tighten door hinge done good ...

and lift off the door. Replacement is the opposite procedure but do not tighten the bolts as you will have to move the hinges to get the door adjustment correct. Once that is done tighten up all bolts

...door to jam stays in position as you tighten the screw. If necessary the trim piecearound the jam can be removed and additional shims installed. Hope that this is a help? Easiest fix is to put one or ...

...door and tighten the hinge bolts as follows. Top hinge, top bolt. Bottom hinge, top bolt. Top hinge, bottom bolt. Bottom hinge, bottom bolt. -Tighten until tight BUT do NOT overtighten. -Refit the ...