Questions & Answers for: Whirlpool ti 1100

whirlpool hd wm 1100 controls locked This is mentioned on the front Panel. Simply Look at the Text Under the DRAIN/SPIN button on bottom right of the HD WD 1100 where it says:- press & hold 3 ...

when turning on oven a f3 keeps showing up Hi, The F3 fault code is indicating an open oven temperature sensor probe or an open oven temperature sensor circuit. The oven sensor probe will need to be ...

how do i know if its my temperature sensor, or heating elemnet that isn't working? HI. You can administer a simple continuity test on the element to confirm failure. A burned out element will show no ...

Oven doesn't seem to be heating to proper temperature. Both elements are hot to the touch when first turned on. Broiling element is red hot when on broil. Baking takes longer than what is reccomended ...

...has gone bad. To solve this issue start by checking the oven temp. sensor for 1100 ohms, if the rating is more then 1100 then it is the sensor that is bad & if the rating is around 1100 then it ...

GR448LXPS ERROR CODE E2F3 Hello, The F3-E2 error code means that the heated well above the setting the tempature was set at. The usual reason the oven would over heat by so much is a defective oven ...

...the problem. To test the sensor it should be unplugged from the wire it plugs into and use a multimeter set to measure ohms of resistiance and check the sensor at ROOM TEMPATURE to be between

...way too hot, burning everthing. Hello Denise, Very likely the reason it overheats so much is a defective oven temperature sensor, the oven temp. sensor is located in the oven cavity and it should be ...

1100 ohms. It must not be grounded to frame on either wire. To replace the sensor remove the screw holding it to the oven and carefully pull the wire through till you get ti the quick connection. Take

...and this is interesting https://forum.allaboutcircuits.com/threads/washing-machine-pcb-power-supply-fault.130710/