...thumping noise 96 Cavalier 4 door. I have a thumping noise coming from the back of the car (sounds like coming from the trunk). The noise sound almost like loose lumber. When you push up and down on ...
...thumping noise I had the tires and alignment checked, put in new drive axles on both sides and still have a thumping noise. Seems to be louder on turns, but I can't tell if it's coming form the front ...
...noise-dull rattle-thumping sound,bumpy roads '05 caravan,can hear a dull rattle-thumping sound,lower front left,near rack&pinion/crossmember?have already replaced front strut assemblies& ...
thumping noise. when you put in drive and back in park it acts like when you don`t stop and put it in drive? If its a front wheel drive, check to see that your cv joint hasnt failed on the front axel.
thumping noise when driving. Slowing of speed increases the noise. i would 1st check out the front tires to make sure that they are not defective, if tires check out ok, then i would put the jeep on a
Question about 1994 Grand Cherokee
...noise came from). After placing the new axel on, the car squeaked. Three months later, it began to thump, thump, growl when driving and turning the wheel, but only in dry weather. Now, the care does ...
...thumping noise when stopped in drive. I can put it into neutral and the thumpping and pulsing goes away. The cause is too low an idle and engine is starving for fuel so it shakes like that.The ...
my corvette makes a thump noise when i put it in drive I would suspect the drive shaft Universal joints are worn. have a shop put it in the air and check them for excessive slack due to wear.
Question about 2002 Intrigue
...thumping noise when acceleration reaches just above 15 miles an hour only happens while accelerating any ideas? THUMP THUMP If the axle nut was put on with an air gun,then the new bearing many be ...
Question about 2002 Intrigue
Thumping noise when I put car in reverse?Ive replaced all motor mounts what else could it be? If the vehicle is rear wheel drive it is the connection at the end of the drive shaft
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
