...thumb wheel there. That is the focus for the viewfinder. Move it up and down to bring the viewfinder into focus. (Don't forget to do this while you are looking through the viewfinder so you can see ...
...simply broken now, or is there a setting that I'm missing? hey, i have one too, just take the camera out of auto adjustment and put it in say, program auto or some other setting on the thumb
Question about D40 Digital Camera with G-II 18-55mm Lens
thumb wheel to adjust exposure. If you're shooting into the sun it can throw off your exposure of the subject in the foreground. Download your manual from Nikon and study it. Good photography involves
...picture, I assumed it was that i blew the bulb and also the three lights on the front were flashing. I replaced the bulb and that didn't fix anything. However I was able to witness that upon turning ...
Question about Ruger Mini 14 Rifle Elevated Scope Mount Silver
thumb wheel on it? It won't tighten up? Is it stripped? Or is the receiver stripped out? You could replace that big screw with a bolt, you would lose your quick detach, Or if the receiver is stripped,
...thumb wheel to be used". Then while in any of the "creative zones" (except "M") half press the shutter then rotate the thumb wheel and this will allow you to move the AEB slider to your desired ...
...thumb wheel on the back of the camera. Try changing that if it has a thumb wheel. Next try it in Auto mode by rotating the dial on the top of the camera to the green setting and see if you get a ...
wheel. It is very loud and the picture does not show at all. What can I do? What has to be done is the color wheel will need changed out before we can go any furthur. While your at it change the lamp.
Question about 961B Beam Drafting Compass UNGRADUATED
picture. It has thumb wheels that tighten and loosen to grip the beam. put one trammel point on the far left and one on the far right of the joined beam. This will give you the largest radius possible
...thumb wheel or the power on. After about 10 try's the orange goes to white, Big V symbol on the screen for about a minute then goes to a "no signal" on the screen appears. Fault with main board. ...
Usually answered in minutes!
1,383 Questions
1,133 Questions
959 Questions
944 Questions
808 Questions