Questions & Answers for: thick legs pictures

legs each transformer. I soldered also the 8 capacitors. Checked the 4 fuses. Main Part of Solutions. The problem was coming from the 2 surfaced mount inductors. That's why there was no supplied power

...thick red lead from the glass of the tube it will be holding high voltage. Once you have found the frame chip it will have 5 or more legs on it just resolder all the legs to pcb. And thats it jobe ...

...legs are not fully soldered to the board. Note: just be careful on the high voltage diode / line ( the one with a thick (like the car distribution wire cable) single wire going to the tube). good ...

...coil [C] as shown. Follow No.1 Cylinder alignment. • Then check the valve clearance. ?? Using a thickness gauge [A], measure the valve clearance between the rocker arm [B] and the valve stem end. ...

...thick one, usually red in colour] goes to the top of the picture tube, and seem to be sucked to it by the help of a rubber ******. That is the above said LOT. It may have 9 to 12 legs soldered to the ...

...legs of the vertical output Ic, and the other is Vertical Output Ic failure. You just open your tv, and locate the vertical output Ic. It can be located by following the wires that goes from the ...

...thick, normally red and blue coloured, and the other two will be thin. Follow the the two thin wires, you will see it to be connected to a plug in point on the printed circuit board. just upside down ...

...thick, usually red and blue coloured, and another two of them will be thin. You just follow the two thin wires, which in turn goes to a plug in adaptor and to the circuit board. Just put the circuit ...

thick, usually colured as red and blue, and the other two will be thin. Follow the two thin wires, and you can see it to be plughed into a socket on the main board. Just put the board upside down, and

...thick, and other two will be thin. Follow the two thine wires, and you will see it as plughed onto the cirucit board. Just upside down the circut board and trace the tracks of that two wires through ...