V8. The car has had all the typical jeep issues I have replaced the tail lamps and the entire air conditioning system. Just recently when I turn on the heat it blows cool air. The blower is fine as it
...V8 What are the steps to replace the radiator and do you have to burp the radiator? If so how? Radiator removal is not that difficult but too long to write out. Pretty much it involves removing the ...
...on the v8's they are both electric. Either way, there is never just one. Your engine has two fans. Was the thermostat and fan sensor replaced.et me know, I'll keep in tough to resolve your
...V8. Radiator cooling fan motor burnt up. Need to find replacement. What we are finding only have 2 wires coming out of motor, we had 3. Connecting wires have 3. What do these three wires do and where ...
...V8 Remove lower radiator hose clamp and lower radiator hose at thermostat housing. Remove thermostat housing mounting bolts, thermostat housing and thermostat. 2000 Jeep Grand Cherokee 4.0l v6Note:on ...
...thermostat located on a 2000 Jeep Grand Cherokee Limited V8 ? Thanks Locate the top radiator hose...follow it down to the motor...the housing that the hose connects to is where the thermostat ...
v8. I changed the water pump and thermostat but it still over heats. Its mostly when I go up a hill though... If I just let it idle it doesn't seem to heat up as bad. Are you sure the radiator fan
where is thermostat located Which engine? Inline 6 its on top front of engine. Has big hose and small hose attached to the housing. V8... look for bottom radiator hose and follow it to the engine
Question about 2000 Grand Cherokee
rad cap and start engine. let it burp till it warms up...the v8 i think has a bleeder hole on or near the thermostat housing. if you changed the thermostat you should make sure the vent hole is on top
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions