Questions & Answers for: thermopile fireplace

...fireplace connected to propane and the pilot light ingnites but the burners won't flame and then will very little and then goes out what it wrong. is pilot flame on the thermopile good, pilot flame ...

Thermopile fails, it fails without any warning. In this particular case, you may need to recheck the batteries in the handheld remotes and the receiver boxes in the fireplace's control compartment

...fireplace,it still wont stay lit Thermocouple keeps the pilot lit. Thermopile keeps the burner lit. Please specify what won't stay lit... If it's the burner, you may need to change the thermopile as ...

how to check a thermopile generator how do I check a thermopile generator to be sure it is working Log in to the Honeywell internet site and ask the question using yur model generator! It is probably ...

...fireplace valve to have a thermopile and not a thermocouple. If the valve has a battery pack or a electrical plug then the chances are that you have a thermocouple but if there is not an external ...

...thermopile on a Lennox Gas Fireplace, Model # MPD4035CNM? First take a picture of the logs so they go back in the same position . re move logs to gain access to pilot block thermopile is the lager ...

fireplace. pilot lights normally. thermopile volts are 420mv after warm-up. after lighting main burner, thermopile voltage drops to about 250mv. after 6-7mins with fire on, fire and pilot both go out.

...fireplace. The main burner would not light. Back burner lit OK. The thermopile had soot on it. I cleaned it and retried, ran OK. Next day same problem. Thermopile had soot on it again. replaced ...

...fireplace older model pilot light comes on will not turn on to heat house change thermopile check the thermopile voltage everything there is working good blew the system out stuff don't know what to ...

...regulator inside. I have a regency c34-10 gas propane fireplace. Could it also be the switch on the side of my gas heater? Thermopile should read 600 millivolts Thermostat has to be millivolts .