Questions & Answers for: thermal printer printing light label

...printer driver to direct thermal mode to solve the problem. We replaced the printer with another printer of the exact same model and this doesn't happen. This indicates a hardware problem. Is there ...

...a Zebra driver and that the label/media settings match your printer. Look at your direct thermal/thermal transfer setting and your media length setting -- especially continuous vs.

printer only works for about the first half of the roll, then it begins to print too lightly to read effectively. Sounds like a faulty Ribbon, check the labels as well to make sure they are not Direct

...printer light turns red. I can get it back to green again by prtessing it twice. If I print another label the problem repeats Have a look at the way the driver is setup, by sound of it you might have ...

...Thermal Label Printer. Everytime I print a label it stops short of the preferated line to rip the label. I adjusted the settings to cut every time and now it goes about a 1/4 inch out too far and the ...

...printing too light. Help. Test labels are fine... This could be caused by the darkness setting coming from the label software / printer driver. It's set too low and that setting will usually override ...

...thermal printer. When I print to it with any application, the data light comes on, but it doesn't print. It has ribbon, media, calibrated, no error lights The data light indicates that the printer is ...

...printer Thermal, but i cant print labels. I have read the manual and follow the instructions. Every time i put labels on the printer, only send me blanks. Can you help me, please Are you trying to ...

...thermal coating on other labels has a different sensitivity than DYMO-branded labels. Also, the perforated holes between the labels made by other manufacturers are frequently not detectable by ...

...printing too light This could simply be old direct thermal labels. Direct thermal labels have a shelf life of about 1 year from the date of manufacture. After that time has lapsed the thermal coating ...