2006 F250 I REMOVED NEGATIVE BATTERY CABLE TO INSTALL A PERFORMANCE MODULE. THE PINS ON THE MODULE DID NOT MATCH UP SO I DECIDED TO SCRAP THAT IDEA I PLUGGED THE HARNESS BACK INTO THE COMPUTER AND THE
...manual there is not good example. i am confuse how i could know where is from so i will set the timing. To set the igntion timing u have to pput #1 cyliner on compreson. After doing such, u have to ...
...manual. heres what you can do and be careful doing it take a lighter and light the burner you should get the burner to light if the gas ratio between propane and natural is not correct when you turn ...
...set a little off TDC. I suspect you are going to see it off by a lot. If it is then you are looking at replacing the timing chain. Hope this helps. could you have put diesel into it by mistake by any ...
...manual and figure out how to diagnose this thing. I expect it would involve inspecting the CKP, the ICM (which you've replaced, but the TFI module is known to have problems, especially when it gets ...
...set on1984 ford 300 6cycl. USA, CAR (FORD) OR AUSTRALIA FORD???? OR WHERE? Ahhh no 4.9L in Australia so is USA (wild guess) no car model told. what is the question here, tell the job at hand or a ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions