...reversed. You will need a diode vhecker to test for a leaky diode as often times a diode will fail under load. Its best to replace a questionable diode if you dont have an actual diode checker
...test a diode I want to see if the diode is good for my GE SPACEMAKER XL1800 is good. To test a diode, first remove it, then use a test meter with a diode check facility. Test component first one way ...
...diode between the battery and the test lead .......take a reading . now reverse the diode take a reading ........ i just tested a diode before writeing this and this is what i got my battey volts ...
meters actually have a diode test setting. Do you have a meter? I'd be glad to work you through it... you can test them with a VOC meter, just do a continuity test. if you read infinity, there no good
Question about Profile Spacemaker Over-the-Range Microwave
...test. To check a diode: Set the meter to to the lowest scale (Rx1) and touch black (-) probe to the cathode of the diode (the end with a band around the diode body) and the red (+) to the anode lead ...
...test a diode, use an ohm meter. Place the red lead from the ohm meter to the anode, "Positive" end of the diode, and the negative lead to the cathode,"Negative" end of the diode. If it is good, you ...
Question about Profile Spacemaker Over-the-Range Microwave
...leads? It appears to be open. Using a digital meter does not have enough forward bias to test the high voltage diode, in most cases it will short or crack making it easy for the meter to
...Diode test. I tested and found that the Diode was bad. I found a local supplier, but it was a different looking diode but he said it was the new version. (Original Diode was rectangular and the new ...
...test the diode for continuity with a multi-meter. Diodes are polarity specific and you should see low resistance with the meter leads in one direction and higher resistance when the meter leads are ...
Question about Profile Spacemaker Over-the-Range Microwave
...test the diode for continuity with a multi-meter. Diodes are polarity specific and you should see low resistance with the meter leads in one direction and higher resistance when the meter leads are ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions