...Test 38. Disconnect bulk head connector to instrument panel. If ohmmeter still indicates continuity, repair white/orange wire for a short to ground in harness, then proceed to Test 38. If ohmmeter ...
...connector terminal A2 (Red wire). If test light illuminates, go to next step. If test light does not illuminate, go to step 12). 4. Connect test light between defogger relay harness connector ...
test lamp to SCB solenoid harness connector. Cycle SCB driver in PCM by Output Test Mode. Test lamp cycle on and off - SCB solenoid is suspect. Test lamp always on - SCB signal short in harness or PCM
Question about 2000 Grand Cherokee
...Test VER-5A.14 Key Off.Disconnect the Trans Solenoid Pack Connector.Remove the Trans Control Relay.Note: Check connectors - Clean/repair as necessary.Using a Ohmmeter, measure the Trans Control Relay ...
Question about 2000 Grand Cherokee
...test this. I can find no connector labeled P1. It also appears that dryer will not even come up in diagnostic test today. This is tested on the matching connector to P3 that leads into the control ...
...Test connector terminal E-wiper switch in LO and mist/intermittent. If battery voltage is not present, replace switch. test connector terminal C-wiper switch in HI. If battery voltage is not present, ...
...Test Connector For Tachometer Test Connector Connect tachometer and timing light to engine (white check connector). Ground test connector (green: 1-pin) with a jumper wire. Check that idle speed is ...
Question about 2009 H3
...connector at the rearview camera. Ignition OFF, test for less than 1.0 ohm between the ground circuit terminal B and ground. ? If greater than the specified range, test the ground circuit for an ...
...test light, backprobe between connector C201 terminal A3 and ground. Does the test light illuminate? -- Go to Step 6 Go to Step 7 6 Repair a poor connection or an open in circuit 10 between the ...
...connector. Test the resistance through the seat cushion heater element. Is the resistance within the specified values? 0.5-2 ohms Go to Step 14 11 Test the resistance through the heated seat switch ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions