Questions & Answers for: tell brake lines leaking 1999

...brake light to come on, and how serious (i.e.: expensive) would it be to fix? 1999 Nissan Maxima: nearly 200K miles, replaced 2 ignition coils (other 4 are going bad), replaced alternator, otherwise ...

...Brake disc adn rotors. Now I see that brakes won't hold except front rt. Fluid leakes out of resr. bleed the brakes and see if it goes away. if you add fluid as your brakes wore down when they ...

leaking brake fluid from the rear tires. on a nissan maxima, how do u fix the leaking brake fluid from the rear tires remove the rear tires and the brake drums and check and see if the wheel cylinders

brake lines come together. When the brake is pumped a tiny bit fluid shoots out. you may have to replace the abs controller thats leaking, you must clean it off and then pump the brake pedal and watch

lines and pumped the brakes and I still lose pressure while engine is running, I can still pump up some pressure but it immediately loses it. No visible leaks, I cannot figure out what the problem is?

...tell me which fuse controls the ABS brakes on a 1999 Nissan Maxima? if they are not on the driver side then check under the hood. there are two fusible links under there 99 nissan maxima brake ligth ...

...nissan maxima 96 se You have an oil resevoir for the clutch under the hood near the Brake master cylinder, make sure it is full. these older Maxima will leak clutch oil over time and it needs to be ...

or stop the noise sometimes go away. can you tell me if the brakes is the cause for such noise or is it my wheel bearings The noise is worn out brake pads. Wheel bearings make a roaring noise or growl

...1999 nissan maxima makes when the back brakes are worn out Squeeling first if it has squeeling tabs. there to let you know the brakes are getting low but if totaly worn out metal on metal grinding ...

losing brake fluid I checkedthe calipers and the brake line to the calipers and they are all dry if you have no indication of a brake fluid leak then you may have a bad master cylinder that has an ...