Questions & Answers for: NorStar tech line

...line outbound, then you should be able to push the button to answer it inbound. Hope this helps. Bill C. www.dyna-tech.us We offer remote programming and tech support for Norstar CICS, MICS and Call ...

...Choose appear and ring on each line you want to answer from that telephone. Hope this helps. Bill C. www.dyna-tech.com We also do remote programming and tech support on Norstar CICS and

in line 1, right now all it has is just a sssssssssshhh noise. Call a tech in that handles the system programming to check the line port if ok and/or call your carrier to report the line as being dead

tech.If you do know then:First find out what line #, do F*0 then press the button and note the full number on the display.i.e. Line 5 in programming is Line 005,  025 or 031 depending on software

...show on the screen Page Zones: SETS SPKR BOTH If a system defaults programming it assigns only lines 1 and 2 to each set.You either had this issue or somebody removed line 3.Call a tech in to

...setup night services for each company via Service Modes.Complex programming.best to call a vendor/tech in for this....roughly one hour

...tone just dead. We were trying to change name on the phone and then line one went dead all other lines work. what did we press to cause this? Call a tech in, name change will not harm a line

...navigate or the password call a tech.otherwise go to Sets/Ext#/Line Access/Line Assignment, enter line # in question, press Change until you see the option you want ie.e appear only or not

i have to push the line ringing to answer Because your phone is not programmed to ring. You need to call your tech/vendor in to program it for you (tech side of programming) known as Configuration.

...tech programming and not admin, you can take a course on how to program and navigate a business Nortel Norstar phone system. It is the system that runs the phones. If you are aware of how to program ...