Questions & Answers for: tailshaft seal

Question about 1994 S-10 Blazer

1 Answer

...rear seal do I need for and automatic transmission for a 1994 Chevy S10 Blazer if its the rear seal where the driveshaft enters the trans you need a transmission output seal for the tailshaft

Ad

Question about 1994 F350 Crew Cab

1 Answer

...transmision Installing a rear seal on the tailshaft of a manual transmision is very easy,,you dont need a manual to do this,,just a good proper sized seal installation tool,,,(you can borrow or rent

Ad

Question about 1990 Suburban

2 Answers

...tailshaft and there are bearings inside of is. Does the yoke seem to be smooth looking meaning no major marks? I would check the rear trans mount at the rear of the trans first. Put a pry bar between ...

...seal. 2wd? If you remove the tailshaft you will be removing the whole overdrive assembly. I would try pulling the driveshaft and seal. Then see if you can remove and install a new bushing. It is quit ...

Question about 1985 Pickup

1 Answer

...is no internal oil seal in the tail housing. Maybe you damaged the seal when refitting the tailshaft.. It is easy to do.. Did you grease the seal so the tailshaft wouldn't damage it upon

seal right at the end of the tailshaft where the driveshaft goes in. Remove the driveshaft,unbolts at the rearend and pulls out of the transmission. Pop the old seal out with a screwdriver and put the

Question about 1986 740

1 Answer

...seal in auto gearbox and was wondering if the tailshaft should slid out or do i have to remove the rear of the gearbox Nope.Not sure about yours but 95% of the tailshafts that I know,just slide ...

Question about 1983 Suburban

1 Answer

...tailshaft seal is out. This job is pretty easy and cheap. First thing, is to remove the driveshaft from the rear axle, slide the opposite end out of the transmission tailshaft, and catch any fluid ...

tailshaft housing. Not between housing and driveshaft. How would i go about.replacing this? Im getting the parts tomorrow and tearing into it. Any help would be great. Thanks ! no great mystery there;

seal out of the gearbox (where the tailshaft goes into the gearbox) i have bought a new seal, undone all the appropriate bolts but the tailshaft will not slide out of the gearbox as it normally should

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...