Questions & Answers for: sync helicopter remote

...sync the controller and helicopter. My way was trial and error and it finally worked. I will post again if I figure out a more exact way to do this Hi Tate, The three channels refer to the control ...

...Helicopter on, wait for flashing, throttle all the way up then down. Then you're ready to go. I had four helicopters that all had the same sync issue.  The remote would blink green and the heli ...

...helicopter.2) Place on level surface and let gyroscopes sync. There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will keep ...

...helicopter.2) Place on level surface and let gyroscopes sync. There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will keep ...

...helicopter on a stable, level surface. Once the on board gyroscopes sync-up and set the "normal" head orientation, the light stops flashing and the helicopter will accept control signals from the ...

...helicopter.2) Place on level surface and let gyroscopes sync. There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will keep ...

...helicopter.2) Place on level surface and let gyroscopes sync.  There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will ...

...helicopter first and place on level surface, this allows gyroscopes to sync up.  Then, after making sure the main rotor control (left joystick) is all the way down, turn on controller, and ...

...sync it and then give it throttle all the lights on the helicopter syart flashing red and it dosent do anything I bought 2 off brand ,of the same remote controlled Helicopters which cost about $30.00 ...

my remote and helicopter will not sync together. They synced together at first but will not now. It's a Exploiter S. try a reset if any