Questions & Answers for: sunroof glass

...sunroof glass past the full open soft stop position. Doing so may damage the sunroof assembly and or the roof top. Connect a jumper wire to the sunroof limit switch soft stop signal circuit at the ...

...glass from the sunroof unit. To install: Position the glass panel in the opening with the logo rearward and slide the panel forward 0.50 in. (12mm). Verify that the attaching nuts are below the top ...

...glass. How does one just close the sunroof to make sure rain does not come in? Are you holding the close button? If you just press the close button once (while the sunroof is open), it should close ...

...Sunroof switch • Front glass panel • Front sunshade • Power supply for the front glass control module and motor assembly logic: RAP relay • Power supply for the power sunroof system: SUNROOF MOD fuse ...

...sunroof glass panel is in the fully closed position.Loosen the forward attaching screws (2) on each side enough to permit the front of the glass to adjust up or down.Adjust the front surface of the ...

...sunroof glass flew out of the car. who can i go to to fix my sunroof glass? with out going to pay 600 dollars to the dealership? try a few of these ...

...sunroof glass. Lift glass out of sunroof opening & set aside in a safe place. Locate "J" shaped cover plate at front of sunroof track assembly. Remove 2 torx bolts from each cover plate. Lift up ...

...Sunroof glass (spoiler type, with glass sliding above roof) • Sunshade • Rail and track assembly upon which the sunroof glass rides • Power supply for the sunroof control module: SUNROOF 20 A fuse • ...

...Sunroof glass, tilt/slide type, with glass sliding between roof and headliner • Sunshade • Rail and track assembly upon which the sunroof glass rides • Sunroof system fuse: sunroof 20 A fuse • Ground ...

...sunroof glass • The sunshade • The rail and track assembly upon which the sunroof glass rides • Power supply for the sunroof control module; SUNROOF 20 A fuse. Important: After a power loss to the ...