suction valves are the most that give low pressure when they are faulty. To check the suction valves, put on the machine in the normal way and as it is working, disconnect the water supply. Than check
Question about Prosumer 20324 Gas Pressure Washer
...pressure washing, no suction is occuring drawing chemicals into stream as before. With engine not running and water from hose running thru wand suction does occur. The system seems like venturi ...
Question about Prosumer 20324 Gas Pressure Washer
...get the power washer to suction in a cleaning solution. it won't **** it in at all. Do you know it will only draw soap at low pressure? Usually there is a way to adjust the nozzle to low
Question about Prosumer 20324 Gas Pressure Washer
suction. run the pressure washer while on mains pressure with the hose on, does this make a difference? if not then probably the unloader is stuck in the pump head. remove unloader , clean and replace
...suction. The entire world of electronics is based on similar principle. When the ball valve wears out, or gets clogged, the pump pressure is not able to lift fluid. Try cleaning valve, but my bet is ...
Question about 2200 PSI Gas Pressure Washer
Pressure washer, I cannot get it to draw a detergent solution. I am using the black soap nozzel, i have a new siphon hose. any ideas? Dismount the bolt that is use to connect the soap line.Turn on the
water is coming out of the soap suction hose there should be a ball check valve in the soap suction hose lets soap in keep water out poke a paper clip in the hole a few times soap will build up there ...
...soap to go in my pressure washer Can' get the soap to go in my pressure washer I dont know about your system but you probably have dirt in your suction valve venturi or injector
Question about BXD2527 Pressure Washer Pump
...suction tube No detergent Spray wand is in high pressure position Turn spray wand tip to low pressure position No detergent Discharge nozzle is obstructed Blow out or remove debris with a fine needle ...
...pressure nozzle and cannot get suction with the soap solution. Are you using a low pressure nozzle ? ( usually the black one with the huge spray opening) Switching to the right nozzle is usually the ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions