Questions & Answers for: suburban rear ac works 3

...Suburban; 1500K; 350 cu inch; 4WD; rear A/C & heater.I have a leak of "green A/C fluid" under rocker panel of right rear side where the 2 heater lines and 2 A/C lines go back to rear AC. The rubber ...

...Suburban rear blower motor not working ! Hi ! My problem: The rear blower motor quit running on a 2004 1500 Suburban, so I only have cold air up front. What I have tried: Checked the fuses under the ...

...Rear AC Issue: Drove the truck to destination and blower worked fine when truck was shut off. Got in it to leave and turned on heat on but no blower. Blower does not run in any of the four positions ...

...suburban rear a/c doesnt get cold but front works great Was told by shop it was rear expansion vlave. Were is the expansion valve locted? Is it an actual expansion valve or is it an orifice tube. the ...

...Suburban rear a/c warm front ice cold I recently changed my compressor, accumulator, and orfice tube. Because of a compressor that was shot. but even when it was working the back would not get cold ...

...ac/heater switch on our 99 GMC subburbon will only allow air to work at the highest output in the front when positioned on #3. whenon 1,2 or 4 no air comes out. the rear air and the middle air work ...

ac was leaking water in the rear 'trunk' area when it was running last summer and now we have 'recharged' it 3 times and it is continually not working after a week. What should we be looking for? Look

...Suburban. The AC is blowing out hot air. I have had the truck for 6 years, every Summer its the same thing. The ac does not get cold, I take it to the mechanic, they put Freon in, fix the leak, etc ...

...Rear Heat Fix, Suburban, Yukon XL Repair! Heating and AC Temperature and Air Delivery Mode Door ... repairpal.com > Problems > Chevrolet > Tahoe Driver/passenger air vents blow hot then cold when ...

suburban warm air out front vents and cold air out rear cabin vents (aux system). Passenger side lower actuator is working. First make sure that the system is full. Possible bad blend door actuator or