...hard enough then the same problem occurs. it does this when both channels are being used either separately or bridged. I can use either channel independently of the oither with no problems. I have ...
...hitting hard but has no sound like it used to. i don't think it is blown though because it doesn't make that rattling sound like when i have blown a sub before? hey been there before u need new rca ...
...subs are fading in and out not bad but i can def tell when they r really hitting and when they arent. Does anyone know how i can get a constant sub power. depends on what subs you are using that amp ...
...subs hit as hard as they used to? one of your subs is wired out a phase for your amp you must refer to proper wiring for that amp to wire two subs it will change the impedance. for more info go to : ...
to make the most of what is a hard hitting amp,but if you must use the speakers you have set the cross over to about 120hrtz to save the main speakers getting to much bass . Hope this helps. CABLE GUY
Question about MRP-M1000 Car Audio Amplifier
...subs then run wire to the amp the amp will see a 2ohm load i have two type-rs hooked up to a mrp-m1000 and its not hitting hard at all! but when one is hooked up it hits harder than two... so is it ...
Question about Cinemate Digital Home Theater System Speaker
sub does not seem to hit hard as it use to i have to turn the system up loud to get the bass in the sub to sound like i want it but when i first got it it wasn't like that it hit hard and i barely had
Question about SWS-1041 Car Subwoofer
...hitting hard but no vibration, why? please help me to fix this issue. I just made a 5.1 power amp last week by my self, i used STK4141 II ic with 24-0-24 5amps transformer for the channel center and ...
subs installed. Its not hitting hard at all. I've adjusted everything on the amp and my double din and nothing helps. Its not a deep bass like im used to. It sounds more like a knock type of bass. I'm
...hard The wiring configuration is highly dependent on the amplifier being used. The subs can handle 250 Wrms each, so I would not recommend putting them in any configuration that results in power ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions