Questions & Answers for: sub zero display mode

Sub-Zero 650/F The refrigerator is not cooling fully. It will hold about 50 degrees, maybe 47 if your lucky. The freezed appears to be OK. Funny thing, the control panel for the refrigerator appears ...

...mode and reset the "PM" counter back to zero. Go to service mode and enter code 24 then enter sub code 04 back to all zeros and exit out and turn the copier off then back on and it should

...display, believe problem is that it is in showroom mode, what can I do to start it Turn the unit off. Press and hold the freezer warmer and colder keys then press on/off button. let go when it comes ...

sub programming mode somehow and we are unable to get register functional again. When Register is switched to Set there is a P displayed and the only function that can be performed is a financial read

...then press 8 start key then copy coun value is reset to zero and displayed on the 7-seg.then press intrupt key the machine goes to sub code input standby mode.pressed CA key simulation is

...display reads Lo C This is lock mode. The unit will enter this mode if the door is read as open for too long. If the door is left closed for about 30 minutes it should come out of it on it's own. If ...

mode after replacing condenser fan, mainly just to see how it works. rE shows 111, Zone temp set to 36 and reads 36 on display. The other thermistors look normal but the rE seems WAY off. Any ideas? I

Sub zero 601R not cooling properly When you restart the unit it will pull down to 34 which is the lowest it will go on the panel. But open the door and let it warm up and display doesn't change and ...

Sub Zero 642 side by side, refrigerator side not working. The freezer side on my 642 works great. The refrigerator side compressor does not kick on under normal conditions. It does run and cool the ...

Sub-Zero 661 Freezer Compressor Always Running I have a Sub-Zero 661 side-by-side. Recently I found that the freezer was getting too cold -18F. I have it set to 0F. I got a Taylor glass-tube ...