...light and 2 pull chains,one for fan speed and another for the light itself.There is usually only one power source for the fan.If it is a split design,then the light can be run off the dimmer,and the ...
stuck in the on position. The fix is to replace it. Salvage yard would be a good cheap source of the part. You could try spraying it internally with electronic cleaner and see if that helps. Make sure
Question about 2-wire Pull Chain Light Switch For Ceiling Fan Lights
...stuck...what should I do? The chain is easily replaced or repaired, sometimes just a drop of oil will get it slipping again. But the hardware store carries the little pull chain switches , they are a ...
...stuck injector, sometimes computer invoking based on something. I would expect that you have a check engine light on, if you do not, that may point you to external leaks only, and not leaking ...
...pull out the fuse for the lights. I am not sure what all is running on that fuse. It may be your main lights or something else. Your hazard light switch appears to be stuck. It may need adjusted or ...
...stuck , press it a few times to see, if you have no luck the get the garage to look at it. Good luck FIXED on my Nissan Note!!! Problem: hazards lights always ON even if the switch is off. SOLUTION: ...
Question about 2009 STS
...stuck? I have pushed the hazard button repeatedly and have tapped it - it does not spring back up. I have shut the car off and restarted hoping it would reboot and allow the button to work - not. I ...
Question about 2005 Grand Caravan
...pull the fuse. Which also controls turn signals and dash gauges along with brake lights Sounds like the hazard switch has failed and is stuck in the on position On the 06 town and country similar ...
...stuck. Will not pull down anymore to turn light on. You will probably have to replace the switch that is controlled by the chain. You will need one withe the same number of wires coming out of it. ...
Question about 2002 Protege
...the fuse is not blown.what is the problem and how can it be fixed? The answer is you have to take the hazard light switch out and replace it. Tap or wiggle the switch to make sure it is not stuck
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions