sticky, The print head then can not pivot betwen the home and print position. The second most likely problem is the wiper blade is stuck to the print head. You can try turning it off and on a few more
...wiper blades, etc), the only major repair cost was the replacement of the timing belt and water pump at 140,000 miles. The recommendation is that the timing belt be replaced at 90,000 (I believe), so ...
...some alcohol, this will often cause the rubber to regain it's "stickiness" and help grab the paper. (Similar to how cleaning your wiper blades with alcohol helps them last longer and wipe
Question about Phaser 8400 Laser Printer
...sticky and a little difficult to remove. Channel locking pliers will normally allow you to remove it with some effort. I suggest putting the block in some pretty hot water . It makes the ink softer ...
...sticky". Apparetly the grease on this assembly had dried a bit. To test this theory, I applied lubrication to this area (grease might be better, but.). I worked the pin a little and it seemed free. ...
a bad wiper blade clutch, but 90 percent of the time the block or sticky blade is the problem. Let me know, we can go from here, but I very strongly suspect you will fix it with one of those two items
...sticky substance. Also, clean the wiper blade rubber with whatever works. The fact that the wiper seems to work correctly when the glass is wet, would seem to indicate that there is no problem with ...
Question about 2000 Windstar
wiper fuse on my transit keeps blowing when on intermediate To blow the fuse it has to be drawing a higher current. Are you using the correct AMP for the wipers? I would try lifting the wipers off the
Question about 2000 Windstar
sticky on the screen stopping the wiper from moving freely. Wipe the screen with a rag using pure screen wash fluid ( not watered down ) or When stationary Try spraying the screen washers whilst it is
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions