Questions & Answers for: Brother DCP sticky door handle

Reset Drum I have a DCP 7020. How do I reset the number after I install a new drum? Take it out and put it back in - the trick is to LEAVE THE FRONT DOOR OPEN after you put it back in. With the door ...

Brother dcp-7020 printer shows error back door open. open the front door then pull away your ink cartridge then clean dust or blur from ink cartridge position then refix ink cartridge again.

into the slot gently and try pulling back bringing the card with it. The tire plug material is very sticky but won't leave any residue to gum up the works

the printer keeps displaying "change drum" If your drum is still good - take it out and put it back in - the trick is to LEAVE THE FRONT DOOR OPEN after you put it back in. With the door still OPEN ...

Back Door is open. Printer will not work. Keep Back Door is open. Printer will not work. Keep getting same message. The black flap inside the rear door has a sensor flag mounted on it. The flag goes ...

printer stopped. said my fuser cover is open. Where is it? The fuser is located at the rear of the printer. Open the rear door and make sure it closes flush all around. If this does not clear the ...

My Brother DCP 7020 won't stop flashing close back door There's a micro-switch that "trips" when the door is opened/closed. It's not sending a "closed" signal to the printer. Clean the switch, with a ...

door and remove the toner cartridge. On most laser printers the toner cartridge is located either in the front of the printer or on the right-hand side. Vacuum underneath the toner cartridge to remove

...I could fix it without purchasing anything! Try cleaning the rollers. You can get cleaning paper(sticky on both sides) from an office supply store. Run it thru a couple of times to see if that ...

ink box full how to change ink box 1.Turn off the printer power switch. Press the front cover release button and then open the front cover. 2.Hold the green handle of the drum unit. Lift the drum unit